Improving Safety Around Recovery Boiler Operations

The recovery boiler is a vital part of the pulp mill but also a source of potential safety hazards for its operators. One of the purposes of the recovery boiler is to recover the pulping chemicals from the black liquor which is done in the form of smelt from the bottom of the furnace. A potential hazard of this process is that if the smelt interacts or has contact with water, an explosion can potentially occur which could injure operators and cause damage to the boiler. Besides the risk of explosion, combustion in the recovery boiler creates very hot gases and highly corrosive molten ash which could be hazardous to operators who are performing physical tasks around the recovery boiler.

In an effort to make operations in the recovery boiler safer, and minimize exposure to unsafe working conditions, Valmet has developed and perfected several auxiliary devices that serve to both automate as well as either remove the need for direct operator involvement or to minimize exposure to unsafe working conditions. Below are four inventions and innovations that have improved the working conditions around recovery boilers and made operation of the boiler more stable.

Smelt Spout Micro Hood Arrangement: One area considered the most dangerous for operators, and one of the leading causes of recordable injuries is the spout deck on a recovery boiler. To make smelts more accessible for cleaning and to improve safety, Valmet has developed mini or micro-hoods have to replace the old large hood systems. The benefits of these systems are:

• Easier access to spouts for manual cleaningSmelt Spout Micro Hood Arrangement
• Easier replacement of spouts
• Minimal hood shower water
• Minimal internal ledges
• Cooling water lines not exposed to smelt
• Minimizes tramp air intake
• Dual shatter jets (ShatterMax™)
• Externally mounted shower bar headers
• More reliable mounting interfaces for the smelt spouts.

Spout Cleaning Robot: The DeckHand™ is another new system designed to improve the safety of operators is the development of an independent robotic arm that performs repetitive tasks. The safety benefits of this robot are:

Spout Cleaning Robot

• Greatly reduces the risk of operators getting injured from splashes of green liquor or smelt
• Cleans spouts, hoods & shatter jets
• Robot camera that allows operators to visually inspect spouts from safe control room
• Safety gates designed to stop robot if any personnel enters the spout deck
• Less personnel at the smelt spouts

Liquor Station with Automated Port Rodder: Working around the liquor guns is another area where operators are at risk with large numbers of lifting and burn injuries being reported annually. To make this area safer, the GunnersMate™ liquor stations were developed. The safety benefits are:

Liquor Station with Automated Port Rodder

• Limited operator exposure to furnace
• Station retractable outside furnace
• Safety door protection from opening
• Ready signal for spraying to start
• Improved operator working conditions
• Auto-cleaning cutter reduces amount of manual cleaning required

Automated Port Rodders: The Roddingmaster™ was developed to limit operators from potential exposure to hot air (300 – 400 °F) and limit exposure to the furnace. The safety benefits of automated port rodders are:

Automated Port Rodders

• Improved operator working conditions
• Large observation port
• Control box easy access for remote isolation
• Ability to change the cutter on the run with minimum exposure time in front of opening

 

At Valmet we can help you with all your recovery boiler safety needs. Contact us for more information.